ESP32‐C6 upgrade for Standalone Edition
This upgrade is possible since the new Wireless-Tag WT0132C6-S5 (ESP32-C6) module is pin-to-pin compatible with the old Ai-Thinker ESP-12F (ESP8266) one.
- better GNSS serial input stability
- better Wi-Fi stability
- (built-in) Bluetooth LE data output
- NMEA TCP data output
Un-solder ESP-12F component from NodeMCU board first, then solder the WT0132C6-S5 module.
In general a lot of Chinese DIY electronics manufacturers are known to behave this way:
- sometimes they may not apply necessary Q.C. before releasing of a product from factory ;
- they may arbitrary change schematics and electronic components from one batch to the next one ;
- they may terminate manufacturing of a board just few months after initial production.
Because of that, author of SoftRF:
- will reject any hardware related claims associated with Wireless-Tag WT0132C6-S5 module. Ask for support from seller or manufacturer ;
- reserves the right to suspend or terminate support of Wireless-Tag WT0132C6-S5 product in the firmware at any time.
For the time being ( Jan '24 ) there were no critical hardware issues reported for current version of the Wireless-Tag WT0132C6-S5. However things my change over the time...
If you have issues with bringing up your new Wireless-Tag WT0132C6-S5 product or just not happy with the module - be prepared to execute your Purchase Protection plan.
| Part | Picture | Source |
|---|---|---|
| Wireless-Tag WT0132C6-S5 4 Mbytes |
|
AliExpress 1 2 3 Alibaba |
- Connect pins RST and EN together with a jumper
-
Follow these instructions
-
Remove the jumper then plug the NodeMCU into your Standalone Edition
-
Open up the SoftRF WebUI status page to inspect if everything is doing good
