v1.7

This change only contains changes for the Cura Profile:

• Significant quality updates based on feedback from @Tenson_UK
  • For the normal profile, set the first layer height to match the rest of the print. (0.2)
  • Set "Initial Layer Horizontal Expansion" and "Hole Horizontal Expansion" to improve quality
  • Set "Top/Bottom Thickness" to improve quality
  • Changed infill logic to increase infill speeds.
    • NOTE: Part strength is slightly weaker, so adjust as needed.
  • Changed print temperature logic for more consistency
  • Changed "Top/Bottom Flow" and "Initial Layer Flow" to improve print quality
  • Set "Combing Mode" to "Within Infill" to reduce the number of retractions.
  • Complete rework of support settings that provides easy removal and good part support.
    • NOTE: Tree supports have no optimization at this time.
  • Adjusted the following experimental settings to improve print quality.
    • "Overhanging Wall Angle"
    • "Overhanging Wall Speed
    • "Small Hole Max Size"
    • "Small Feature Initial Layer Speed"
• Regrouping/ordering of overrides to match base setting order

Full Changelog: v1.5...v1.7