N1 Autopilot firmware check and lightbridge2 pairing

It is highly recommended to check your autopilot's firmware before a flight. Use DJI Assistant 2 (Windows version, not Mac version), to check it.

If you see the screen below, you have to upgrade to the latest version V1.3.1.00 (2016.04.13), otherwise, the software packages we provide won't work at all.

Out of box N1 firmware version

This should look like

Latest firmware version

After the upgrade, your lightbridge2 (remote controller) will beep like this. https://drive.google.com/open?id=0B-0CTsFowMRVM2lBczZBek01WTQ

This means you need to pair your rc to the drone. These procedures are addressed in the following document (page 40)

https://dl.djicdn.com/downloads/m100/M100_User_Manual_EN.pdf

The figure below shows the rc pairing button that needs to be pressed over the pairing procedures (It's difficult to find and use a sharp tweezer)

rc pair button

You may need to calibrate your rc after the firmware upgrade (please plug your phone/tabelt into the remote). Please follow instructions displayed on your DJIGO app.