L) Troubleshooting

Troubleshooting

No Relays:

1. module config for board and relay type
2. subnet set in app, upload to module
3. section count and width set
4. auto off
5. section assigned to relay
6. switch assigned to section
7. if auto on, sensor counts/unit and base rate are needed

No UPM:

1. speed
2. working width
3. sensor control settings
4. aog connected
5. module connected
6. sensor counts/unit
7. base rate
8. pid values sent to the module?
9. control type, is it a valve or motor?

No Rate Adjust:

1. in manual mode the master switch must be on
2. minimum pwm too low

Motor won't turn off:

1. minimum pwm should be 0