Set Gadfly z-order

[tbreloff]

Layers seem to be randomly ordered on the screen:

I think it's possible to specify an order to them, so I should do that.

[rohitvarkey]

@tbreloff Yes! You can specify orders in Gadfly.

From the docs at http://gadflyjl.org/ ...

Ordering of layers can be controlled with the order keyword. A higher order number will cause a layer to be drawn on top of any layers with a lower number. If not specified, default order for a layer is 0.

plot(layer(x=rand(10), y=rand(10), Geom.point, order=1),
     layer(x=rand(10), y=rand(10), Geom.line, order=2))

[tbreloff]

Thanks for the time-save... I knew I saw that somewhere.

On Nov 6, 2015, at 4:09 PM, Rohit Varkey Thankachan [email protected] wrote:

@tbreloff Yes! You can specify orders in Gadfly.

From the docs at http://gadflyjl.org/ ...

Ordering of layers can be controlled with the order keyword. A higher order number will cause a layer to be drawn on top of any layers with a lower number. If not specified, default order for a layer is 0.

plot(layer(x=rand(10), y=rand(10), Geom.point, order=1),
layer(x=rand(10), y=rand(10), Geom.line, order=2))

—
Reply to this email directly or view it on GitHub.