Hardware Buttons

Opening the PandwaRF enclosure

You can access the buttons after opening the PandwaRF enclosure. Use a coin or similar tool as shown in the picture below.

Button positions on PandwaRF V3

Buttons	Short press	Long press (>2s)
SW1	Transmit config 1	Shutdown PandwaRF
SW2	Transmit config 2	Whitelist bypass mode
SW3	Transmit config 3	Factory reset + Whitelist clear procedure
SW4	Transmit config 4	Clear Alternative Advertizing Device name
SW5	Reset	Reset
SW4 + SW5	-	Recovery Mode

Button positions on PandwaRF V4

Buttons	Short press	Long press (>2s)
1	Transmit config 1	Shutdown PandwaRF
2	Transmit config 2	Whitelist bypass mode
3	Transmit config 3	Factory reset + Whitelist clear procedure
4	Transmit config 4	Clear Alternative Advertizing Device name
4 + Toggle Off then On	-	Recovery Mode

Whitelist bypass mode

Temporarily turn off usage of the whitelist until next connection. Pressing SW2/Button 1 for 2s allows to connect to a phone which is not in whitelist. This is valid for a single connection. To be granted access to PandwaRF permanently, this phone must then bond.

Reset to default settings (factory reset)

To reset PandwaRF HW settings to factory values:

• Press SW3/Button 4 for 2s or
• Press SW3/Button 4 and reset at the same time

Factory reset will:

• Delete all bonding information. This allows any phone to connect to PandwaRF.
• Disable Auto power off
• Stop autonomous action (brute force, etc...) (Rogue Pro/Rogue Gov only)
• Clear Alternative Advertizing Device name (Rogue Gov only)