Added Device in Z-wave JS UI still showing as new device in HA #2960
-
|
I added Z-wave JS UI to home assistant after disabling Z-wave JS. After a bit of work, I successfully added the z-stick Gen 5 controller via Z-wave JS UI and it shows in the control panel. However, the device is showing as a new Z-wave device in the HA integrations area. The only option is to configure or ignore the device. What should I do? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 3 replies
-
|
If this is the USB device you're referring to, just ignore it. |
Beta Was this translation helpful? Give feedback.
-
|
Yes, it is a usb z-wave z-stick Gen5 controller attached to the usb port. |
Beta Was this translation helpful? Give feedback.
-
|
That's HA's USB discovery feature. It doesn't know the stick is being used with ZUI. If you attempt to set it up, it will install the official add-on, so it's safe to ignore. |
Beta Was this translation helpful? Give feedback.
-
|
Thank you! |
Beta Was this translation helpful? Give feedback.
If this is the USB device you're referring to, just ignore it.