Traffic Shaping DGA4132

It is a useful script to easily configure traffic shaping on Tim DGA4132 (TimHub)
This script uses qdisc with htb as traffic shaper and sfq as queuing disciplines.

To avoid incompatibility with the technicolor standard QoS it will be disabled once it is installed and re-enabled upon uninstallation.

it is highly recommended to disable ipv6.

Install

From a shell interface run:

wget --no-check-certificate https://github.com/xMase/Traffic-Shaping-DGA4132/releases/latest/download/mShaper.tar.gz -O /tmp/mShaper.tar.gz
mkdir /tmp/mShaper; tar xvzf /tmp/mShaper.tar.gz -C /tmp/mShaper && chmod +x /tmp/mShaper/setup.sh
/tmp/mShaper/setup.sh install

Uninstall

From a shell interface run:

/tmp/mShaper/setup.sh uninstall

Configuration

Change the test configuration located in /etc/config/mshaper.

I remember that:

• eth0 ... eth3 => are the ethernet interfaces
• eth5 => is the 5Ghz wifi interface
• wl0 => is the 2.4Ghz wifi interface

In interface/class section:

• downlink => upload
• uplink => download

An interface can have more class and each class can have multiple ip/mac filters that manage the available bandwidth.

# 5Ghz wifi interface
config interface 'eth5' 
    # max interface upload  
    option 'tot_dl' '3000kbit'
    # max interface download 
    option 'tot_up' '30000kbit'
    # list of classes added to this interface
    list class '7mb'
    # ...
    
# 2.4Ghz wifi interface same as before
config interface 'wl0'  
    # maximum upload for the filters of this class, 
    # this value is optional 
    # if not added will take the total upload value of the interface
    option 'tot_dl' '3000kbit' 
    # maximum download for the filters of this class, 
    # this value is optional 
    # if not added will take the total download value of the interface
    option 'tot_up' '30000kbit'
    list class '7mb'
    # ...

# class that limits the filters 
config class '7mb' 
    option 'dl' '324kbit'
    option 'ul' '7000kbit'  
    # list of filters added to this class
    list filter 'tv'
    list filter 'tablet'
    # ...

# mac based filter
config filter 'tv'     
    option 'mac' '01:01:01:01:01:01'

# ip based filter
config filter 'tablet'
    option 'ip' '192.168.1.25'
    # IPv4 Subnet Calculator
    # https://www.calculator.net/ip-subnet-calculator.html
    option 'subnetmask' '32'

Usage

Default operations:

• /etc/init.d/mshaper enable => to enable the script on starup
• /etc/init.d/mshaper start => to start the script
• /etc/init.d/mshaper stop => to stop the script
• /etc/init.d/mshaper disable => to disable the script on starup

Debug:

• logread => to read mshaper log

Contribute code

If you have any ideas/solutions/improvements to be included in this project, feel free to submit a pull request.