BrewPi Device Setup

The setup page is a simplified version of original one of BrewPi. Before the setup, Erase EEPROM to initialize the EEPROM. Then, list all devices available by Refresh Device List. Two types of devices are concerned: the sensors and the actuators.

All sensors found by BPL should be listed with temperature readings. Use exclusive Device Slot number, choose the Function, and press apply.

For cooling and heating control, you will need to chose Pin type, which is Not Inverted for SSR and Inverted for mechanical relays in most case.

After editing and applying all devices, click Refresh Device List to review the setting. If the assigned devices are not listed in the "installed" section, you might need to Erase EEPROM and try again.

To uninstall a device, set the Function to None.