Tritium WaveSculptor 22 CAN DBC

A CAN DBC file for the Tritium WaveSculptor 22 motor controller.

Note: This assumes that your motor controller has a base address of 0x80 (the Device Identifier 0x4 shifted left by 5). If this is not the case, just edit the addresses to match your configuration. Kvaser Database Editor is a pretty good option for a free DBC GUI editor.

The CAN Frame ID format (using 11-bit CAN IDs) is as follows:

+---+---+---+---+---+---+---+---+---+---+---+---+---+---+---+---+
| x | x | x | x | x | d | d | d | d | d | d | m | m | m | m | m |
+---+---+---+---+---+---+---+---+---+---+---+---+---+---+---+---+
 0xf 0xe 0xd 0xc 0xb 0xa 0x9 0x8 0x7 0x6 0x5 0x4 0x3 0x2 0x1 0x0

m = Message ID
d = Device ID
x = unused

Requirements

These instructions use eerimoq/cantools over SocketCAN to decode messages with the DBC. If you're using PCAN-Explorer or something similar, feel free to ignore those steps/requirements and directly import the DBC.

# Ensure that can-utils is installed
sudo apt-get update
sudo apt-get install can-utils

# Start the slcand userspace daemon and create slcan0 interface
# We assume 500 kbps bitrate, see (https://elinux.org/Bringing_CAN_interface_up)
sudo slcand -o -c -s6 /dev/ttyUSB0 slcan0

# Bring up the SocketCAN interface
sudo ifconfig slcan0 up

# Install cantools (either in a virtualenv or something).
pip install cantools

Usage

# View the DBC file
cantools dump dbc/wavesculptor_22.dbc

# Decode CAN messages with the DBC
candump slcan0 | cantools decode --single-line dbc/wavesculptor_22.dbc