PADD

PADD (formerly Chronometer2) is a more expansive version of the original chronometer.sh that is included with Pi-Hole. PADD provides in-depth information about your Pi-hole.

Setup PADD

More in-depth information about setting up PADD can be found in this repo’s wiki.

• Get a copy of PADD by running:

cd ~
wget -N https://raw.githubusercontent.com/jpmck/PADD/master/padd.sh

• Make PADD executable by running

sudo chmod +x padd.sh

• Make the Raspbian distro autologin at boot by running below two:

sudo systemctl disable [email protected]

sudo systemctl enable [email protected]

• You can check which user gets logged in automatically (Raspbian default is "pi") by running:

grep autologin /etc/systemd/system/[email protected]

• Set PADD to auto run by adding the following to the end of ~/.bashrc:

# Run PADD
# If we’re on the PiTFT screen (ssh is xterm)
if [ "$TERM" == "linux" ] ; then
  while :
  do
    ./padd.sh
    sleep 1
  done
fi

One line version

cd ~ ; echo "if [ \"\$TERM\" == \"linux\" ] ; then\n  while :\n  do\n    ./padd.sh\n    sleep 1\n  done\nfi" | tee ~/.bashrc -a

• Reboot your Pi-Hole by running sudo reboot. PADD should now run when your Pi-Hole has completed booting.

Updating PADD

• Just run

cd ~
wget -N https://raw.githubusercontent.com/jpmck/PADD/master/padd.sh

Note: if you are already running Chronometer2 v1.3.1 or below, you’ll need to follow these instructions!

FAQ

Answers to frequently asked questions can be found in this repo’s wiki.