drivers: usb: xhci: set HID bit in streaming endpoint contexts

The xHC may commence Host Initiated Data Moves for streaming endpoints -
see USB3.2 spec s8.12.1.4.2.4. However, this behaviour is typically
counterproductive as the submission of UAS URBs in {Status, Data,
Command} order and 1 outstanding IO per stream ID means the device never
enters Move Data after a HIMD for Status or Data stages with the same
stream ID. For OUT transfers this is especially inefficient as the host
will start transmitting multiple bulk packets as a burst, all of which
get NAKed by the device - wasting bandwidth.

Also, some buggy UAS adapters don't properly handle the EP flow control
state this creates - e.g. RTL9210.

Set Host Initiated Data Move Disable to always defer stream selection to
the device. xHC implementations may treat this field as "don't care,
forced to 1" anyway - xHCI 1.2 s4.12.1.

Signed-off-by: Jonathan Bell <[email protected]>

drivers/usb/host/xhci-mem.c

@@ -715,6 +715,14 @@ void xhci_setup_streams_ep_input_ctx(struct xhci_hcd *xhci,
 	ep_ctx->ep_info &= cpu_to_le32(~EP_MAXPSTREAMS_MASK);
 	ep_ctx->ep_info |= cpu_to_le32(EP_MAXPSTREAMS(max_primary_streams)
 				       | EP_HAS_LSA);
+
+	/*
+	 * Set Host Initiated Data Move Disable to always defer stream
+	 * selection to the device. xHC implementations may treat this
+	 * field as "don't care, forced to 1" anyway - xHCI 1.2 s4.12.1.
+	 */
+	ep_ctx->ep_info2 |= EP_HID;
+
 	ep_ctx->deq  = cpu_to_le64(stream_info->ctx_array_dma);
 }
 

drivers/usb/host/xhci.h

@@ -465,6 +465,8 @@ struct xhci_ep_ctx {
 #define CTX_TO_EP_MAXPSTREAMS(p)	(((p) & EP_MAXPSTREAMS_MASK) >> 10)
 /* Endpoint is set up with a Linear Stream Array (vs. Secondary Stream Array) */
 #define	EP_HAS_LSA		(1 << 15)
+/* Host initiated data move disable in info2 */
+#define EP_HID			(1 << 7)
 /* hosts with LEC=1 use bits 31:24 as ESIT high bits. */
 #define CTX_TO_MAX_ESIT_PAYLOAD_HI(p)	(((p) >> 24) & 0xff)