Helm Fundamentals - lab setup

These instructions will guide you through configuring a GitHub Codespaces environment that you can use to run the course labs.

These steps must be completed prior to starting the actual labs.

Create your own repository for these labs

• Create your own copy of this repository by forking the skillrepos/helm-fun-v2 project as a template into your own GitHub area.
• You do this by clicking the Fork button in the upper right portion of the main project page and following the steps to create a copy in your-github-userid/helm-fun-v2 . Make sure to uncheck the "only the main branch" checkbox as shown below.

Configure your codespace

1. In your forked repository, start a new codespace.

   • Click the Code button on your repository's landing page.
   • Click the Codespaces tab.
   • Click Create codespaces on main to create the codespace.
   • After the codespace has initialized there will be a terminal present.

Start the Kubernetes cluster and complete setup

2. Setup an alias and run the setup command in the codespace's terminal (This will take several minutes to run...):

   alias k=kubectl
   minikube start
   

   • The output should look similar to the following.

😄  minikube v1.31.2 on Ubuntu 20.04 (docker/amd64)
✨  Automatically selected the docker driver. Other choices: none, ssh
📌  Using Docker driver with root privileges
👍  Starting control plane node minikube in cluster minikube
🚜  Pulling base image ...
💾  Downloading Kubernetes v1.27.4 preload ...
    > preloaded-images-k8s-v18-v1...:  393.21 MiB / 393.21 MiB  100.00% 206.91 
    > gcr.io/k8s-minikube/kicbase...:  447.62 MiB / 447.62 MiB  100.00% 56.57 M
🔥  Creating docker container (CPUs=2, Memory=2200MB) ...
🐳  Preparing Kubernetes v1.27.4 on Docker 24.0.4 ...
    ▪ Generating certificates and keys ...
    ▪ Booting up control plane ...
    ▪ Configuring RBAC rules ...
🔗  Configuring bridge CNI (Container Networking Interface) ...
    ▪ Using image gcr.io/k8s-minikube/storage-provisioner:v5
🔎  Verifying Kubernetes components...
🌟  Enabled addons: default-storageclass, storage-provisioner
🏄  Done! kubectl is now configured to use "minikube" cluster and "default" namespace by default

Labs

3. After the codespace has started, open the labs document by going to the file tree on the left, find the file named codespace-labs.md, right-click on it, and open it with the Preview option.)

This will open it up in a tab above your terminal. Then you can follow along with the steps in the labs. Any command in the gray boxes is either code intended to be run in the console or code to be updated in a file.