These are open SCAD files for a custom quadcopter that uses 1 inch PVC pipe and fittings for some of the construction. Original inspiration for the build was taken from this instructables. My original design started off very similar to the build in the link however as can be seen from the pictures below my design has evolved quite a bit. The primary changes have been to augment or replace parts with 3d printed ones. At the moment the motor mounts and landing struts are 3d printed as a single piece. The I also have now added 3d printed mounts for the flight controller and power break out board.
This is really just a personal project I don't intend to update this repo with full build notes. If would like to use any of the parts feel free to.
The can all be printed with out supports. I use an Anet A8 to print them so you don't need a precision machine. I primary print in PLA or PLA+ my pieces break frequently but usually after a crash that I think would warrant it, I am not a great pilot :).
