#Janusb - Serial Port Plugin for Janus Gateway

---

Janusb provides a very simple interface to the low level serial port code necessary communicate with Arduino, St MicroControllers and all the IoT.

---

JanUsb, Why?

Why not!

How To Use

Using janusb is pretty easy because it is pretty basic. The main goal of janusb is to send/recive JSON messages from web application to microcontroller (and vice-versa) without the knowledge of hardware.

To Install

Once you have installed all the dependencies and janus-gateway (https://github.com/meetecho/janus-gateway/), get the code:

    git clone https://github.com/kmos/janusb
    cd janusb

Then just use:

    sh autogen.sh

After that, configure&compile adding the path of janus installation:

    ./configure --prefix=/opt/janus
    make
    make install

To also automatically install the default configuration files to use, also do a:

    make config

To Use

Html:

The "janusb" project allows the communication between STM32 microcontroller and a web page. janusb is able to command the STM32 (on/off leds) and to show the data acquired from it (temperature and accelerometer). The communications is based on JSON message exchange and it is made possible by Janus WebRTC Gateway © Meetecho 2015.

Stm32f4Discovery:

You can use the example in Microcontroller dir to flash the Stm32f4 Microcontroller and test the plugin.

Arduino:

To Configure