UnitySpec

UnitySpec is a BDD solution for Unity3D. It is based on the Gherkin specification language. This project is based on the code from SpecFlow.

UnitySpec has been tested in Unity 2022.3 for both .Net Standard 2.1 and .Net Framework

This project uses UnitySpec.General v0.1.0 and UnitySpec.Generator v0.2.0.

Installation

• Recommended installation through the Unity Package Manager
  • Open Unity Package Manager
  • Go to + -> Add package from git URL.. and enter https://github.com/UnitySpec/UnitySpec.git

UnitySpec requires the Unity Test Framework to run tests

Setup

1. Create a test folder in Unity.

This can either be a EditMode or PlayMode testfolder, see the documentation from the Unity Test Framework for more information on test folders.

2. Open the assembly definition of the test folder:
   1. Add UnitySpec.Runner.editor to the Assembly Definition References.
   2. Add BoDi.dll to the Assembe References.
   3. Press Apply.
3. Optional: Create folders for feature files and step definition files inside the test folder.
4. Open Settings and navigate to UnitySpec, set the folder containing the feature files under Specification folders.

You can add multiple paths for multiple folders. You can also edit the search behaviour, default is searching the listed directories and all their subdirectories.

Usage

1. Write scenarios After installation feature files can be added in Unity by right-clicking in the project window > Create > New Feature. Scenarios should be written in Gherkin, a Gherkin reference can be found here.

2. Create test files Once the scenario is written UnitySpec can be used to autogenerate test files to test this scenario. Go to Window > UnitySpec to open the UnitySpec Window. Click on the button to generate test files. The files are generated at the same location as the feature files.

3. Write step definitions For each step used in the scenarios, a step definition has to be written. See the documentation on step definitions for more information.

4. Run test files Open the test runner. For each feature file a test file should be visible, and for each scenario a test in that file. Double click a test to run it, or press the play button to run all.

   If you see no tests you might need to refresh. Do this by going to the project window and pressing ctrl + R, alternatively, right-click > Refresh, or clicking outside Unity and going back.