This is usable beta code. However, no promises and no guarantees!

ddrescue-verify

Use MD5 sums to verify a ddrescue image with a partly defective drive.

• If you need a tool which does a binary compare of the image with the drive, skipping just the unreadable parts, this is not what you are looking for.
• If you are happy with MD5 checksums comparing the data, then this is what you want.

This approach here allows you to check, that the image was successfully transferred, without transferring it back over the wire. Note that normal MD5 sums will fail for this, because md5sum will break on unreadable parts of the drive.

Usage:

git clone https://github.com/hilbix/ddrescue-verify.git
cd ddrescue-verify
git submodule update --init
make
make install

After you created some drives image with ddrescue /dev/drive drive.img drive.log you do:

Create the checksum-file to verify:

ddrescue-verify drive.img drive.log > drive.check

Do the verification:

ddrescue-verify -i /dev/drive drive.check > drive.verify

(You should at least use option -i in case a drive has developed more errors. See also option -d.)

You can chain this, of course, if you think, you need it:

ddrescue-verify drive.img drive.log | ssh remote ddrescue-verify -dui /dev/drive - > drive.verify

drive.verify is not able to keep all information of drive.log. So make sure you do not loose drive.log, this is your original and stays the correct source of information!

The output drive.verify is suitable to be fed into ddrescue again to update the image with the found differences:

ddrescue /dev/drive drive.img drive.verify

Beware that ddrescue alters drive.verify, so it overwrites all the possibly interesting comments which are written into it by ddrescue-verify.

For all options, see

ddrescue-verify -h

See the Wiki for a more elaborate example.

Important:

• By default, ddrescue-verify skips block which are less than 64 KiB. To change that use option -s, for example -s0 to read all small areas, too.

• The checksums by default use blocks of 1 MiB. With this setting, drive.verify needs 6 MiB for each 100 GB of image (rule of thumb, YMMV).

Note about MD5:

Using MD5 is not really a problem here. MD5 is fast, well understood and completely up to the task of verifying if some data was changed on the drive due to hardware failures. Hardware usually does not mount cryptographical attacks to data, and will not exploit the MD5 weakness by chance.

License:

Parts are under GPL v2. The main source is CLLed.

This Works is placed under the terms of the Copyright Less License, see file COPYRIGHT.CLL. USE AT OWN RISK, ABSOLUTELY NO WARRANTY.