NewRemoteSwitch library v1.2.0 (20140128) for Arduino 1.0 Made by Randy Simons http://randysimons.nl/

This library provides an easy class for Arduino, to send and receive signals used by some common "new style" 433MHz remote control switches.

There are two styles of remote:

• "old style", which uses switches or a dial to set the house code. Use the RemoteSwitch library instead.
• "new style", which use a button on the receivers to "learn" a signal. Use this library.

License: GPLv3. See ./NewRemoteSwitch/license.txt

Latest source and wiki: https://bitbucket.org/fuzzillogic/433mhzforarduino

Installation of library:

• Make sure Arduino is closed
• Copy the directory NewRemoteSwitch to the Arduino library directory (usually /libraries/) See http://arduino.cc/en/Guide/Libraries for detailed instructions.

Default installation demo:

• Connect the data-out-pin of a 433MHz receiver to digital pin 2. See photo. (Note: your hardware may have a different pin configuration!)
• Start Arduino, and open the example: File -> Examples -> NewRemoteSwitch -> ShowReceivedCode or ShowReceivedCodeNewRemote.
• Compile, upload and run
• Open serial monitor in Arduino (115200 baud)
• Press buttons on a 433MHz-remote, and watch the serial monitor

Changelog: NewRemoteSwitch library v1.2.0 (20140128) for Arduino 1.0

• Revisited receiving dim-levels. Now it is always optional, check dimLevelPresent to see if it was transmitted. This change might break your code, as SwitchType::on_with_dim is removed.
• Added NewRemoteTransmitter::sendGroupDim.
• Added Dimmer example. Thanks to a Bitcoin donation, I could actually test it!

NewRemoteSwitch library v1.1.0 (20130601) for Arduino 1.0

• BUGFIX: in many occasions, when receiving a dim-level, the code was rejected even if the signal was correct.
• Support decoding A-series transmitters which transmit a dim-level in combination with an on-signal, instead of a dim-signal.
• Uses NewRemodeCode::on, ::off, ::dim, ::on_with_dim instead of 0, 1, 2 and 3, for better readability. This change is backwards compatible.
• Updated examples to use the new NewRemodeCode::on, ::off, ::dim and ::on_with_dim notation.
• Reduced memory usage (Flash, RAM)

NewRemoteSwitch library v1.0.0 (20121229) for Arduino 1.0

• Support for receiving A-series Klik-aan-klik-uit remote. (NewRemoteReceiver)
• With examples to test and demonstrate.