This project is a fork of the no-longer-maintained oblique/create_ap.

Features

• Create an AP (Access Point) at any channel.
• Choose one of the following encryptions: WPA, WPA2, WPA/WPA2, Open (no encryption).
• Hide your SSID.
• Enable Wi-Fi Protected Setup (WPS) with push-button or PIN methods.
• Disable communication between clients (client isolation).
• IEEE 802.11n (Wi-Fi 4), 802.11ac (Wi-Fi 5), 802.11ax (Wi-Fi 6) support.
• Internet sharing methods: NATed or Bridged or None (no Internet sharing).
• Choose the AP Gateway IP (only for 'NATed' and 'None' Internet sharing methods).
• You can create an AP with the same interface you are getting your Internet connection.
• You can pass your SSID and password through pipe or through arguments (see examples).

Dependencies

General

• bash (to run this script)
• util-linux (for getopt)
• procps or procps-ng
• hostapd
• iproute2
• iw
• iwconfig (you only need this if 'iw' can not recognize your adapter)
• haveged (optional)

For 'NATed' or 'None' Internet sharing method

• dnsmasq
• iptables

Installation

Generic

git clone https://github.com/oblique/create_ap
cd create_ap
make install

ArchLinux

pacman -S create_ap

Gentoo

emerge layman
layman -f -a jorgicio
emerge net-wireless/create_ap

Examples

No passphrase (open network):

create_ap wlan0 eth0 MyAccessPoint

WPA + WPA2 passphrase:

create_ap wlan0 eth0 MyAccessPoint MyPassPhrase

WPS Push Button or PIN entry:

create_ap wlan0 eth0 MyAccessPoint MyPassPhrase
create_ap --wps-pbc wlan0            # Device will have 2 minutes to connect
create_ap --wps-pin wlan0,12345678   # Enroll PIN 12345678 for device requesting it

AP without Internet sharing:

create_ap -n wlan0 MyAccessPoint MyPassPhrase

Bridged Internet sharing:

create_ap -m bridge wlan0 eth0 MyAccessPoint MyPassPhrase

Bridged Internet sharing (pre-configured bridge interface):

create_ap -m bridge wlan0 br0 MyAccessPoint MyPassPhrase

Internet sharing from the same WiFi interface:

create_ap wlan0 wlan0 MyAccessPoint MyPassPhrase

Choose a different WiFi adapter driver

create_ap --driver rtl871xdrv wlan0 eth0 MyAccessPoint MyPassPhrase

No passphrase (open network) using pipe:

echo -e "MyAccessPoint" | create_ap wlan0 eth0

WPA + WPA2 passphrase using pipe:

echo -e "MyAccessPoint\nMyPassPhrase" | create_ap wlan0 eth0

Enable IEEE 802.11n

create_ap --ieee80211n --ht_capab '[HT40+]' wlan0 eth0 MyAccessPoint MyPassPhrase

Client Isolation:

create_ap --isolate-clients wlan0 eth0 MyAccessPoint MyPassPhrase

Systemd service

Using the persistent systemd service

Start service immediately:

systemctl start create_ap

Start on boot:

systemctl enable create_ap

License

FreeBSD