fix(console): switch USB PHY to OTG when OTG is used for console

On ESP32-S3 with the default efuse settings, USB PHY is connected to
the USB_SERIAL_JTAG peripheral. If USB OTG peripheral is used for the
console, we need to additionally switch the PHY to USB OTG, otherwise
we won't get any output.

Closes #12437

components/bootloader_support/src/bootloader_console.c

@@ -1,5 +1,5 @@
 /*
- * SPDX-FileCopyrightText: 2020-2022 Espressif Systems (Shanghai) CO LTD
+ * SPDX-FileCopyrightText: 2020-2023 Espressif Systems (Shanghai) CO LTD
  *
  * SPDX-License-Identifier: Apache-2.0
  */
@@ -18,6 +18,9 @@
 #include "esp32s2/rom/usb/cdc_acm.h"
 #include "esp32s2/rom/usb/usb_common.h"
 #endif
+#if SOC_USB_SERIAL_JTAG_SUPPORTED
+#include "hal/usb_phy_ll.h"
+#endif
 #include "esp_rom_gpio.h"
 #include "esp_rom_uart.h"
 #include "esp_rom_sys.h"
@@ -98,6 +101,9 @@ void bootloader_console_init(void)
     esp_rom_uart_usb_acm_init(s_usb_cdc_buf, sizeof(s_usb_cdc_buf));
     esp_rom_uart_set_as_console(ESP_ROM_USB_OTG_NUM);
     esp_rom_install_channel_putc(1, bootloader_console_write_char_usb);
+#if SOC_USB_SERIAL_JTAG_SUPPORTED
+    usb_phy_ll_int_otg_enable(&USB_WRAP);
+#endif
 }
 #endif //CONFIG_ESP_CONSOLE_USB_CDC