Control bosch intelligent filling loop?

[ricostuart]

i have a greenstar 8000 installed with the added bosch intelligent filing loop which helps remotely fill up the system if there is a detected low pressure occurance (with confirmation before filling happens). Is there a way of being informed via the gateway ems v2 and homeassistant? Would like to get a warning come up if low pressure is detected and that I can remotely increase pressure if required (ie if i am away but the wife is at home to check for leaks ,etc)

[proddy]

You could create a trigger in HA that checks the value of sensor.boiler_syspress?

[ricostuart]

I do have a trigger set in HA as a warning message, but I can’t find a way of controlling the filling loop however.

…

On 10 May 2024, at 9:20 am, Proddy ***@***.***> wrote: You could create a trigger in HA that checks the value of sensor.boiler_syspress? — Reply to this email directly, view it on GitHub <#1756 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABMI5SS3KQNIAF2BMWKLCBLZBR7OTAVCNFSM6AAAAABHQGMWF6VHI2DSMVQWIX3LMV43SRDJONRXK43TNFXW4Q3PNVWWK3TUHM4TGNZZHA3TK>. You are receiving this because you authored the thread.

[proddy]

You could remotely force an initiation of the filling process (I'm guessing Worcester has an app or something) and then use EMS-ESP to monitor all the commands on the EMS bus. If there are, we can simulate that action (https://emsesp.github.io/docs/Troubleshooting/#im-missing-certain-data-from-an-ems-device) but I'm doubtful as it's probably all tightly integrated inside the boiler.