The official OpenEmbedded/Yocto BSP layer for Altera SoCFPGA platforms
This layer works with poky and Angstrom
Please follow the recommended setup procedures of your OE distribution.
It is important to understand the support and release of u-boot-socfpga and linux-socfpga in the github.com/altera-opensource repositories. Only currently supported and maintained releases/branches are available in the repository. As such, supported kernel and u-boot releases are updated regularly in currently supported meta-altera branches. Kernel and u-boot releases which are no longer supported are removed.
Only branches listed appropriately in https://wiki.yoctoproject.org/wiki/Stable_branch_maintenance are maintained.
This layer has a few providers for the kernel. These are the linux-altera, linux-altera-ltsi, and linux-altera-ltsi-rt kernels. There are also linux-altera-dev and linux-altera-ltsi-dev kernels which follow the current development versions of those kernels.
To specify a linux-altera kernel, add the following to your conf/local.conf
PREFERRED_PROVIDER_virtual/kernel = "linux-altera"
PREFERRED_VERSION_linux-altera = "4.3%"
or for the linux-altera-ltsi kernel
PREFERRED_PROVIDER_virtual/kernel = "linux-altera-ltsi"
PREFERRED_VERSION_linux-alterai-ltsi = "3.10%"
Please note that older kernels will not compile with GCC 5+ and you will need to specify in your conf/local.conf to revert to older 4.9 toolchain.
All of the supported machines select default uboot configurations and devicetrees. These selections can be overridden in the local.conf or by defining your own machine in your own layer.
An example of the is the DE0-Nano-SoC board, which is a supported configuration in the Cyclone5 machine definition.
UBOOT_CONFIG = "de0-nano-soc"
UBOOT_EXTLINUX_FDT_default = "../socfpga_cyclone5_de0_nano_soc.dtb"
The above overrides the uboot configuration, "de0-nano-soc" is a target in u-boot, and configures distroboot to indicate the de0-nano-soc devicetree. Please keep in mind that not all targets are using distroboot in u-boot and may require u-boot environment changes.
The default Toolchain for ARM in Angstrom is the linaro toolchain. To specify the use of this toolchain in Yocto add the following to conf/local.conf
GCCVERSION = "linaro-5.2"
SDKGCCVERSION = "linaro-5.2"
DEFAULTTUNE = "cortexa9hf-neon"
To use older kernels not supported by GCC 5+ you will need to use the 4.9 toolchain.
For Yocto: GCCVERSION = "linaro-4.9" SDKGCCVERSION = "linaro-4.9" DEFAULTTUNE = "cortexa9hf-neon"
For Angstrom:
ANGSTROM_GCC_VERSION_arm = "linaro-4.9%"
Send pull requests, patches, comments or questions to [email protected]
Maintainer(s): Khem Raj [email protected]