This app allows you to connect your INNR Devices to Homey

Supported Devices:

RB 285 C, BY 285 C
RB 265, BY 265
RB 250 C,
RF 261
RF 263, BF 263
RF 264,
RF 265, BF 265
SP 110, SP 120, SP 222, SP 220
RB 185 C, BY 185 C
FL 130 C
RB 162, RB 165, RB 175 W, BY 165
RB 145, B 245
RS 125, RS 122, RS 225
RS 128 T, RS 228 T, RS 229 T
RS 230 C
BY 178 T, RB 178 T, RB 278 T
RB 148 T, RB 248 T
PL 110, PL 115
RSL 110
DL 110 N, DL 110 W, SL 110 N, SL 110 M, SL 110 W
UC 110, FL 110, ST 110
RC 110

Remarks

INNR Remote.

Pairing takes time and the message shows you have to put the device into pairing.
But leave it as is, the pairing goes on a few moments later.

Flows are work in progress and program buttons are not (yet) supported! Only with the slider in LIGHTS position, button -, + and on/off can be used with button 1-6. For example: put the slider into LIGHTS stand. Push shortly a num button followed by -, + or on/off. Long press -, + is also supported and are present as tokens within flows.
Available tokens:

Button (number): 1, 2, 3, 4, 5, 6
Type (string): "- short", "+ short", on, off, "- long", "+ long", stop

Slider on the remote in SCENES position, commands are broadcasted and applied to group 0. If i stand correct, this applies to all ZigBee devices, but could not test it, because i have no other ZigBee brands in use with Homey.

Feedback:

Any requests please contact me on Slack
Please report issues at the issues section on Github