SUPER RACER - Calibrate macro does not complete calibration steps

[seekis]

Enstop calibration starts, but I get a Unknown command:"SET_PIN"error after each re-home. Firmware reboots and console shows Running Delta_calibration and then Delta_calibration complete, but does not do the calibration. Also does not do bed_mesh calibration.

[danorder]

This sounds related to your other problem. namely it doesn't have the variables file or know the location of it. basically if calibrate has a issue it'll end or do nothing to avoid. a endless loop. but, i'll check the code i may have a oversite on the error messages or lack of in this case.

[andreamassaro9]

@danorder I have the same problem on Flsun SR with version 3 and main branch (the error is in backend.cfg, changing only this file all works well). With the version 2.5, that I'm actually using, it works like a charm.

[danorder]

Which linux device is this on, so i can check a few. I may need to add a 4th option, for file dirs. Older versions of installs have a symlink to the old directory which could be it, since the sr is just pins file. or i may just be overlooking something on the sr. This is beta state until i flip over to the sr whch should be quite soon, but, i shall check configs on a "clean " install again, since its possible my variables file has all the triggers so im not seeing this behavior. again, its easier to p.m me on fb / troubleshoot this usually leads to quicker solutions / bug finding, Other notes., make sure you have the latest files. since ive been changing / debugging a bit this week, The file is bascialy a backup off my current printer, so this behavior is a bit strange.

…

On Sat, Sep 23, 2023 at 11:26 AM andreamassaro9 ***@***.***> wrote: @danorder <https://github.com/danorder> I have the same problem on Flsun SR with version 3 and main branch (the error is in backend, changing only this file all works well). With the version 2.5, that I'm actually using, it works like a charm. — Reply to this email directly, view it on GitHub <#9 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AR4KIEFTWK4IQ6RM5VT2AIDX34SULANCNFSM6AAAAAA45G6GPE> . You are receiving this because you were mentioned.Message ID: ***@***.*** com>