User Guide: OpenLRS

TauLabs supports directly detecting packets from OpenLRS when using a board that has an RFM22B module (e.g. Sparky2 or BrushedSparky).

Binding

https://vimeo.com/124850842

Note: you should make sure to bind your OpenLRS with telemetry turned off. I have tried with FrSky SmartPort and had success but this is less tested.

1. in the HwSparky2 settings set the Radio field to "OpenLRS"
2. Save settings
3. If you have previously bound to OpenLRS and want to bind again, go to the UAVObjectBrowser and erase OpenLRS
4. Reboot board
5. You should see the RF LED blinking at 5 Hz
6. Put the OpenLRS TX module in binding mode
7. You should see the RF LED stop blinking

At this point you should be bound and can perform input configuration like normal.