Aquila x3 nozzle problems #172
-
|
I have the Aquila X3 with the N32 processor. I installed the firmware, but I get a low temperature error. I thought something in the printer was damaged or disconnected, so I checked everything and reverted to the stock firmware to verify, and it works fine. However, with this firmware, it simply does not work. BIN file name: Aquila_N32_IND_UBL-ProUI-EX-12-12
|
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
|
Did you run a PID tune? |
Beta Was this translation helpful? Give feedback.
-
|
No, I haven’t done a PID tune yet, but I’ll give it a try. Thanks for the response; I’ll see if it helps stabilize the temperature |
Beta Was this translation helpful? Give feedback.
Did you run a PID tune?