Hide the BED Icon

[eerthanaK]

Since I am using a chamber and not using a bed, I have disabled the bed temperature. Additionally, I need to remove or hide the bed icon from the BIGTREETECH TFT50 V3 display.

I am using Marlin software on the mainboard.

[rondlh]

That's good to know, thank you for the information.

[zonalimitatore]

Where you have disabled the HB? Just in Marlin config.h or also in TFT firmware (config.ini)?

Heated Bed Support
Options: [disable: 0, enable: 1]
heated_bed:0

[eerthanaK]

Where you have disabled the HB? Just in Marlin config.h or also in TFT firmware (config.ini)?

Heated Bed Support Options: [disable: 0, enable: 1] heated_bed:0

I disabled the heated bed in the marlin config. h and TFT firmware. But even then It is flashing from the heated bed and chamber in the display status screen

[github-actions]

This issue has been automatically marked as stale because it has had no activity for the last 60 days. It will be closed in 7 days if no further activity occurs. Thank you for your contribution.

[eerthanaK]

Good Morning Team, Already, I do the heated_bed: 0 is disabled in touch screen display. status screen is enabled but the chamber and bed icon is showing alternatively. If the status screen is disabled in chamber Icon only shown. Regards & Thanks Keerthana T

…

On Thu, Jul 11, 2024 at 6:00 PM Zonalimitatore ***@***.***> wrote: Where you have disabled the HB? Just in Marlin config.h or also in TFT firmware (config.ini)? Heated Bed Support Options: [disable: 0, enable: 1] heated_bed:0 — Reply to this email directly, view it on GitHub <#2943 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/A5AL5PYMFFKZKVW4LUHFQ4DZLZ3H3AVCNFSM6AAAAABJZMFAIKVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDEMRSHAYTCOJQGM> . You are receiving this because you authored the thread.Message ID: ***@***.*** .com>

[NOVAXIM]

I will join this postulate.
I do not have a heated bed, but when I choose "Preheat" I have (Heat) "Both" and "Hotbed", instead of limiting the options to "Nozzle" only. On status screen "Bed" the tile is present but it is ok.
Of course, I have disabled hotbed in Marlin and TFT configurations.

[github-actions]

This issue has been automatically marked as stale because it has had no activity for the last 60 days. It will be closed in 7 days if no further activity occurs. Thank you for your contribution.