Bluetooth: btusb: driver to enable the usb-wakeup feature

BT-Controller connected as platform non-root-hub device and
usb-driver initialize such device with wakeup disabled,
Ref. usb_new_device().

At present wakeup-capability get enabled by hid-input device from usb
function driver(e.g. BT HID device) at runtime. Again some functional
driver does not set usb-wakeup capability(e.g LE HID device implement
as HID-over-GATT), and can't wakeup the host on USB.

Most of the device operation (such as mass storage) initiated from host
(except HID) and USB wakeup aligned with host resume procedure. For BT
device, usb-wakeup capability need to enable form btusc driver as a
generic solution for multiple profile use case and required for USB remote
wakeup (in-bus wakeup) while host is suspended. Also usb-wakeup feature
need to enable/disable with HCI interface up and down.

Signed-off-by: Sukumar Ghorai <[email protected]>
Signed-off-by: Amit K Bag <[email protected]>
Acked-by: Oliver Neukum <[email protected]>
Signed-off-by: Marcel Holtmann <[email protected]>

drivers/bluetooth/btusb.c

@@ -1088,6 +1088,10 @@ static int btusb_open(struct hci_dev *hdev)
 	}
 
 	data->intf->needs_remote_wakeup = 1;
+	/* device specific wakeup source enabled and required for USB
+	 * remote wakeup while host is suspended
+	 */
+	device_wakeup_enable(&data->udev->dev);
 
 	if (test_and_set_bit(BTUSB_INTR_RUNNING, &data->flags))
 		goto done;
@@ -1151,6 +1155,7 @@ static int btusb_close(struct hci_dev *hdev)
 		goto failed;
 
 	data->intf->needs_remote_wakeup = 0;
+	device_wakeup_disable(&data->udev->dev);
 	usb_autopm_put_interface(data->intf);
 
 failed: