DEPRECATION NOTICE:

This firmware has been deprecated as a result of moving from Atmel AVR to NXP Kinetis microcontrollers.

You're welcome to check out the new firmware.

Ultimate Hacking Keyboard firmware

This is the firmware of the Ultimate Hacking Keyboard.

Fetch the firmware

Please make sure to clone this repo with:

git clone --recursive [email protected]:UltimateHackingKeyboard/firmware.git

This way the LUFA submodule will be cloned too, which is a necessary dependecy.

Customize the keymap

Switch to the mac vs pc branch if you use a Mac vs Linux/Windows. This will set up a reasonable default keymap.

git checkout mac or git checkout pc

Now, edit the array in right/DefaultKeyMap.c to customize your keymap.

Build the firmware

Install the necessary buld tools on your system such as AVR GCC and AVR Libc. Then go into the right directory and type make. The resulting firmware image is uhk-right.hex.

Upload the firmware

Please note that during this process the UHK will become temporarily unusable, so be sure to have another keyboard at your disposal to be able to enter commands.

1. Install avrdude on your system. You should use avrdude version 6 or later because earlier versions may not work properly.

• On Linux: apt-get install avrdude (or something else if you use another package manager)
• On Mac: brew install avrdude --with-usb

2. Switch the right keyboard half to bootloader mode. For this, put a magnet near the back of the right keyboard half around the bottom outside corner. It can be a fridge magnet or even the magnet of the other keyboard half.

• If pressing the keys on the keyboard doesn’t do anything anymore then you’ve succeeded.
• Don’t worry, you can unplug the USB cable and plug it back any time to make the keyboard usable again.

3. Locate the device file that popped up when you switched the keyboard to bootloader mode. It should be something like /dev/ttyUSB0 on Linux and /dev/cu.usbmodem1411 on Mac.
4. Substitute YourDeviceFile in the following command with the above device file and enter it: avrdude -p atmega32u4 -P YourDeviceFile -c avr109 -U flash:w:uhk-left.hex
5. If everything went well then the UHK reenumerated as a keyboard device running the new firmware.