Ender 3 V3 SE/KE improvements

[bistory]

• Set brim_width to 5mm (instead of 0)
• Added new 0.24 quality profile

[SoftFever]

Thank you 👍

[Orel-A]

Hi, guys.
Some issues I've found that I think should be reviewed for the V3 KE.

1. The Internal Solid Infill in Line Width is set to 0. Shouldn't it be set to something? I also saw it in the config of the SE though.
2. The Max Layer Height Limit is set to 0.36. I think this is too high as I've encountered weak layer adhesion at this height. I think it should be lowered to 0.32. People on the web are recommending no more than 80% of the nozzle diameter afterall.
3. I saw in Creality Print that the retraction length for the V3 KE is set to 0.8, while in Orca it's set to 0.5.
4. The default supports settings for the V3 KE are too hard to pull off the print. Base pattern spacing, top interface layer and top interface spacing should be changed. I think they should match the V3 SE settings.
5. Z-hop is set to 0.1, this is too low, the bedslinger has a bit of z-axis wobble on acceleration causing the nozzle to knock on the print.

Thank you.

[bistory]

Hi, guys. Some issues I've found that I think should be reviewed for the V3 KE.

1. The Internal Solid Infill in Line Width is set to 0. Shouldn't it be set to something? I also saw it in the config of the SE though.

2. The Max Layer Height Limit is set to 0.36. I think this is too high as I've encountered weak layer adhesion at this height. I think it should be lowered to 0.32. People on the web are recommending no more than 80% of the nozzle diameter afterall.

3. I saw in Creality Print that the retraction length for the V3 KE is set to 0.8, while in Orca it's set to 0.5.

4. The default supports settings for the V3 KE are too hard to pull off the print. Base pattern spacing, top interface layer and top interface spacing should be changed. I think they should match the V3 SE settings.

5. Z-hop is set to 0.1, this is too low, the bedslinger has a bit of z-axis wobble on acceleration causing the nozzle to knock on the print.

Thank you.

Hi,
Thanks for your feedbacks !

1. 0 means it uses the nozzle diameter, but it can be increased to .42, it will make the change !
2. I didn't try .36, I will decrease the value
3. 0.8 is too high and can cause underextrusion, .5 has been tested and approved
4. Ok, I didn't have any problem but I trust you (I don't have the machine anymore)
5. Ok, I didn't have any problem but I trust you (I don't have the machine anymore)