Welcome to SiEPIC_EBeam_PDK Discussions! #230
Replies: 4 comments
-
|
Hello Prof. Lukas, my question is, "how can we add PIN to the design circuit in Klayout"? |
Beta Was this translation helpful? Give feedback.
-
|
Hi @Likynti25, The SiEPIC EBeam PDK fabrication process does not currently support P and N implantations and therefore this device is not part of the library. Other process you can try that have this capability is the AMF process for which there's a confidential SiEPIC_AMF_PDK for that you can access through: |
Beta Was this translation helpful? Give feedback.
-
|
Thank you very much for your response.
…On Thu, 21 Jul, 2022, 11:34 pm Mustafa Hammood, ***@***.***> wrote:
Hi @Likynti25 <https://github.com/Likynti25>,
The SiEPIC EBeam PDK fabrication process does not currently support P and
N implantations and therefore this device is not part of the library.
Other process you can try that have this capability is the AMF process for
which there's a confidential SiEPIC_AMF_PDK for that you can access through:
https://www.cmc.ca/amf-silicon-photonics-general-purpose/
—
Reply to this email directly, view it on GitHub
<#230 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/A2FDOQ7VTRYBLXCMFZYSDQTVVGGKDANCNFSM4UWBCVIA>
.
You are receiving this because you were mentioned.Message ID:
***@***.***>
|
Beta Was this translation helpful? Give feedback.
-
|
Dear Prof. Lukas, do you know which website in github could provide the free silicon photonic PDK? |
Beta Was this translation helpful? Give feedback.
-
👋 Welcome!
We’re using Discussions as a place to connect with other members of our community. We hope that you:
build together 💪.
To get started, comment below with an introduction of yourself and tell us about what you do with this community.
Beta Was this translation helpful? Give feedback.
All reactions