Home Accessory Architect v12.7.1 Merlin

Changelog v12.7.1:

• Setup Mode:
  • Added information about current SSID and BSSID configured WiFi.
  • Changed behavior of WiFi AP on updated devices: they will have WiFi AP enabled if it was not setup before.
  • Changing WiFi Mode will remove WiFi AP password and re-enable WiFi AP automatically, in the same way than changing or removing WiFi settings.
• Only ESP32, ESP32-S and ESP32-C chips:
  • Hardware PWM: Increased maximum frequency to 29KHz.

Changelog v12.7.0:

• Setup Mode:
  • Added a new way to manage WiFi AP. Now it is possible to disable it completely, or setup a password. When a password is set, WiFi AP will not be disabled when device connects to network.
  • Updated devices will have WiFi AP disabled. To reenable it, enter in setup mode and check WiFi AP.
  • New installations will enable WiFi AP by default.
• Revert back to wolfSSL 3.13.0 to save flash.
• Some minor improvements.
• Only ESP8266:
  • Changed initial GPIOs state from disable to input, to avoid some hardware issues with several devices. To take effect, a complete power cycle is needed (Cutting power).

Changelog v12.0.0:

• BREAKING CHANGES !!! Check Migration Guide

Read Wiki for more info.