Update README.md

[qwewer0]

Description

This Issue Queue is for Marlin bug reports and development-related issues, and we prefer not to handle user-support questions here. (As noted on this page.)

contributing.md:

Note: Please don't file an issue to ask a question. You'll get faster results by using the resources below.

Benefits

Less misinformation.

Configurations

None

Related Issues

None

[sjasonsmith]

I think it would be good to add links to the support resources we tend to reply with to issues. Some adaptation of this canned reply should work:

This Issue Queue is for Marlin bug reports and development-related issues, and we prefer not to handle user-support questions here. (As noted on this page.) For best results getting help with configuration and troubleshooting, please use the following resources:

• MarlinFW.org Marlin Documentation
• RepRap.org Marlin Forum
• Tom's 3D Forums
• Facebook Group "Marlin Firmware"
• Facebook Group "Marlin Firmware for 3D Printers"
• Marlin Configuration on YouTube
• Marlin Discord server. Join link: https://discord.gg/n5NJ59y

After seeking help from the community, if the consensus points to a bug in Marlin, then you should post a bug report.

[qwewer0]

@sjasonsmith I will leave that to the marlin masters, because I don't know what would look good or practical.

[sjasonsmith]

@qwewer0 you pointed out the discrepancy, which is probably all you really needed to do right now. I assume thinkyhead will pop in at some point and take care of it.