Skip to content
This repository has been archived by the owner on Sep 3, 2020. It is now read-only.

Simon Says, Who's on First and Memory

GamingGuyTyler edited this page May 31, 2018 · 1 revision

Simon Says

An illustration of the Simon Says module.

This is like one of those toys you played with as a kid where you have to match the pattern that appears, except this one is a knockoff that was probably purchased at a dollar store.

One of the colored buttons will flash, and from the table that KAaNE outputs, the defuser presses the button that corresponds to that button. Serial Number identification can be found in the Wires section of "Wires, Buttons and Keypads", Strikes are explained in the Proper Use section of "Installation and Proper Use", and Yes/No questions are explained in the Wires section of "Wires, Buttons and Keypads".

Who's on First

An illustration of the Who's on First module.

This contraption is like something out of a sketch comedy routine, which might be funny if it wasn't connected to a bomb. I’ll keep this brief, as words only complicate matters.

The NATO Phonetic Alphabet is strongly recommended, as the words needed to input into KAaNE is hard to communicate normally.

A chart of the NATO Phonetic Alphabet, with semaphone, morse code and code of signal identification.

Firstly, in KAaNE, input the word on display in lower caps. If there is no word, simply input a space. Then, it should ask you about a word in a certain position. Word ordering starts from the top left word, and goes in reading order (Left to right, downwards upon the end of a line.) Again, input the word in lower caps. Lastly, it should give you a list of words. Press the button with the word that comes up first in the list. Again, in reading order. Repeat this process until the module is defused.

Memory

An illustration of the Memory module.

Memory is a fragile thing but so is everything else when a bomb goes off, so pay attention!

There are 5 stages, and in each one you have to press the correct button. Pressing the wrong button will send you back to the 1st stage, and in KAaNE there is currently no way to go back, so be careful! All you have to do is input the display number, answer a question about a certain button (if there is a question), press said button, and move on. These inputs are number only and does not accept word inputs. Doing so will cause you to restart in KAaNE.