Variants

Variants are a set of parameters to configure FOC firmware for a specific use.

• Platformio - Remove the semicolon in front of the desired Variant in platformio.ini file
• Others - Uncomment the desired Variant by removing the leading // in Variant selection section of config.h file

VARIANTS	ADC	USART	NUNCHUK	PPM	PWM	IBUS	HOVERCAR	TRANSPOTTER	SKATEBOARD	HOVERBOARD
CONTROL	ADC	USART	I2C	PPM	PWM	USART	ADC	ADC	PWM	USART
DEFAULT CABLE	LEFT	RIGHT	RIGHT	RIGHT	RIGHT	RIGHT	LEFT	LEFT	RIGHT	BOTH
CONTROL MODE	VOLTAGE	VOLTAGE	VOLTAGE	VOLTAGE	VOLTAGE	VOLTAGE	TORQUE	TORQUE	TORQUE	VOLTAGE
INPUT CMD1 CMD2	POT POT		MID POT MID POT	MID POT MID POT	MID POT MID POT	MID POT MID POT	POT POT	POT MID POT	N/A MID POT	SIDEBOARD SIDEBOARD
MIXER CMD1 CMD2	STEER SPEED	STEER SPEED	STEER SPEED	STEER SPEED	STEER SPEED	STEER SPEED	BRAKE THROTTLE	DISTANCE STEER	N/A THROTTLE/BRAKE	ANGLE LEFT ANGLE RIGHT
AUTO CALIBRATION	YES	YES	YES	YES	YES	YES	YES	NO	YES	NO
CURRENT MAX SPEED LIMIT	YES	YES	YES	YES	YES	YES	YES	NO	YES	NO

For the configuration/customizing of the variants, please check each variant's wiki page.

Dual Inputs

The firmware supports the input to be provided from two different sources connected to the Left and Right cable, respectively. To enable dual-inputs functionality uncomment #define DUAL_INPUTS in config.h for the respective variant. Various dual-inputs combinations can be realized as illustrated in the following table:

Left	Right	Availability
ADC(0)	UART(1)	VARIANT_ADC
ADC(0)	{PPM,PWM,iBUS}(1)	VARIANT_{PPM,PWM,IBUS}
ADC(0)	Sideboard(1*)	VARIANT_HOVERCAR
UART(0)	Sideboard(1*)	VARIANT_UART
UART(1)	Nunchuk(0)	VARIANT_NUNCHUK

⁽⁰⁾ Primary input: this input is used when the Auxilliary input is not available or not connected.
⁽¹⁾ Auxilliary input: this inputs is used when connected or enabled by a switch^(*). If the Auxilliary input is disconnected, the firmware will automatically switch to the Primary input. Timeout is reported only on the Primary input.

With slight modifications in config.h, other dual-inputs combinations can be realized as:

Left	Right	Possibility
Sideboard(1*)	UART(0)	VARIANT_UART
UART(0)	{PPM,PWM,iBUS}(1)	VARIANT_{PPM,PWM,IBUS}
{PPM,PWM,iBUS}(1)	Nunchuk(0)	VARIANT_{PPM,PWM,IBUS}