encumbrance of work and cutres gloves #65695
Merged
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Summary
Balance "varsize/less encumber for work/cutres gloves"
Purpose of change
Work and cut-resistant gloves didn't have the VARSIZE flag which resulted in unduly high encumbrance values. Cut resistant gloves were especially crazy at 40 encumbrance (yet showed up on gun using enemies a lot despite that encumbrance making guns nearly unusable!)
Describe the solution
Lower encumbrance of both to 20+varsize. This is roughly in line with other gloves (the tactical gloves are 1.5mm thick and had 15 + VARSIZE encumbrance, these are each 2mm)
Describe alternatives you've considered
Give neoprene or rubber palms to the cut-resistant gloves as some such ones IRL have.
Complexify the coverage of the work gloves but I don't think they need it, leather glove with cotton liner is simple but more or less representative enough to work.
Testing
Additional context