Keypad Bezel print

[liamamiller]

Hi all. Any tips on printing the keypad bezel with Cura? I've tried twice with support enabled and it's snapped both times as I'm trying to remove the support structure. Taking a break from it for a day or two now. What settings did you use to print yours? I don't see any documentation on settings for printing certain/any parts.

Cheers!

[Ricky3Nut]

It's been awhile since I printed mine so I'd have to go back and see if I can recall anything from looking at my print file. But with Cura I typically set my support density at 10% or 15% maximum so its easier to remove. I vaguely recall it being a little tedious to cleanup and I used my cutting snips to trim out the underside just tried to take time and care. Sorry, I know that's not very much help! ⁣Get BlueMail for Android ​

…

On Jan 9, 2023, 17:21, at 17:21, liamamiller ***@***.***> wrote: Hi all. Any tips on printing the keypad bezel with Cura? I've tried twice with support enabled and it's snapped both times as I'm trying to remove the support structure. Taking a break from it for a day or two now. What settings did you use to print yours? I don't see any documentation on settings for printing certain/any parts. Cheers! -- Reply to this email directly or view it on GitHub: #32 You are receiving this because you are subscribed to this thread. Message ID: ***@***.***>

[liamamiller]

@Ricky3Nut - appreciate the advice! I'll have another go at it in a few days and hopefully will have some better luck.

[CircuitSetup]

This file is actually for Cura: https://github.com/CircuitSetup/Time-Circuits-Display/blob/master/Hardware/3d%20Files/cura_keypad_bezel-v2.3mf

You should be able to use the support settings from that. Also, ironing is turned on so the top surface is smooth.