Usage Notes and Instructions:
Requirements: dac-8u12e.dll , and all the subVI's (must be in same folder as this VI)
-
Please ensure that the DAC & ADC are connected to the correct USB/Com port. Ensure that the DAC and ADC drivers are active (the blue/red 8 icon should be shown in your system tray). Now you are ready to use the remote control power supply. Open the "Power_Supply_main_Control.vi" and press Run!
-
To turn the Power Supply ON/or OFF, click on "Relays Control On", then choose "POWER ON/or POWER OFF" from the Measurement Contol box to your left, then click on "Relays Control Off" again.
-
Choose the voltage value (0- 50 V) for each of the channels in the "Voltage Input Interface", then DAC and the Voltage output values will be displayed atuomatically.
-
You can check for the current (nA) values for any of the 8Th channels, one at a time. Choose from the Meausrement control box (I1 - I8), then press on "Relays Control On" to be displayed and press "Relays Control Off" to turn it off after you done. All the current meausrmets will be diplayed in Channels from 1- 8.
%. NOTE: Please make sure to deenergize the relays (click on "Relays Control Off") after each time you use it before you go to th next selection.
% NOTE: Flip all 8 channels and the main switch to the "REMOTE" position for computer control opration.
% NOTE: You can STOP the program at any time by pressing STOP button.