Slicer profile

[Flo082002]

Hi,
it would be great if you could upload your used slicer profile to Github.
Best regards
Flo S

[toke]

That would be great.
I'm experimenting with an Vulcan and an 0,8mm Nozzle on one of my Printers.
Actually this wastes a lot of time and Material.
Maybe we should share Problems and Solutions and Profiles. At the moment I can't share one that I'm happy with. I produced about 20 v18 Bands until now, most of them are great but the print time can be optimized a lot. I tried to follow some of the tips of the Author @yschroeder but was not able to reproduce the printing times and quality.

As I tried to increase the layer height > 0.3mm I had some Layer delamination problems although the Perimeters where rock solid.

Maybe a Profiles or a Table of settings would be great.

I'm not sure if there is an other way to communicate other that GitHub Issues about it.

[toke]

My Current Config for Artillery Sidewinder X1 - Nozzle 0,8mm:
https://gist.github.com/toke/d99073d89af2b8544be4e1af698f012f
The Results are great.

[yschroeder]

Delamination issues mostly arise from too low temperature. If you press the filament really fast through the hotend, it might not reach the set temperature but stay cooler. PETG becomes very "crispy" and delaminates if extruded too cool. Try to increase the temperature.

I don't want to supply complete profiles here. Instead, I want to point out the relevant settings for the users so they can adapt them to their printer. If we supply the full profile, there will be a lot of settings in them that have nothing to do with printing fast...

[yschroeder]

If too low temperature is common problem when printing fast, we should add a section to the readme about this phenomenon.