Voron V2.4 350mm (with a lot of V2.2 bits still on it)
- Toolhead
- 📄Stealthburner toolhead
- 📄Orbiter 1.5 extruder (LDO motor version) - mounted with 📄this mod
- 📄Trianglelab Dragon High Flow with 📄Bondtech CHT 0.4mm nozzle
- If I were buying today, I'd probably get a Rapido instead.
- Hardware Upgrades
- 📄Fabreeko HoneyBadger textured PEI
- LDO-42STH40-2004MAH(VRN) A/B motors
- Honestly I'd stick with the OMC motors from the sourcing guide. Didn't get much quality increase out of the upgrade to 0.9° motors, just lower speeds 🤡
- Single Hiwin MGN9 rail on X
- 📄Genuine Gates brand pulleys/idlers in gantry
- 📄BTT Smart Filament Sensor
- Mods
- 📄Klicky w/ 📄auto z calibration
- Chamber thermistor
- 📄Bed fans
- Umbilical
- i.e. "flappy cable". No X/Y cable chains.
- This saves a fair bit of weight on the X axis, and I have not had a single wire break since (I had a lot of wire breaks with cable chains and got sick of them.) It's also WAY easier to service. You do lose a bit of Z height, though.
- I just did this the janky way - I just wrapped the wires up and zip tied the far end to the Z chain, and the toolhead side to the reverse bowden tube. There are prettier mods out there for it.
- Toolhead X endstop & 📄relocated Y endstop
- Allows for umbilical.
- The Y endstop relocation is also available as part of the pin mod below.
- The toolhead X endstop is my own mod, and is outdated now. Not sure what other options are currently available, haven't looked into it.
- 📄Pin mod
- 📄GE5C mod
- Gantry backers
- 📄MGN9 Y backers
- 📄Titanium X backer
- These prevent the gantry from 📄warping with heat.
- Frame thermistor
- Used for sofware frame thermal expansion compensation (to combat thermal drift. Allows me to print from cold, without heat soaking. Though I do still wait for a minimum chamber temp to be reached.)
- This is a giant rabbit hole, be warned. Please don't ask me for help with this (sorry)
- Used for sofware frame thermal expansion compensation (to combat thermal drift. Allows me to print from cold, without heat soaking. Though I do still wait for a minimum chamber temp to be reached.)
- 📄Decontaminator nozzle brush
- Voron V2.2 handles & single panel front door
- PiCam with some random Thingiverse mount
- 📄Annex Engineering twist-lock panel clips
Excuse the hazy panels. Fact of life with ABS.
Photos show AB-BN toolhead + smooth PEI. I have since upgraded to Stealthburner + Fabreeko HoneyBadger textured PEI.
