The TX/RX-switch is a tool for signal sensitive or PTT switching for HAM radios incl. pcb schematics.
This is still "work-in-progress (WIP)" so I do NOT take any kind of responsibility for damages/data losses!
You can use this at your own risk without guarantees and put device on non conductive surface or enclosure!
If you like the new design yo are free to share it!
Have fun :)
-
1x Custom PCB by WodoWiesel
-
1x USB-X cable for power supply
-
1x THT-SPDT relay +5V
-
3x THT-BNC female socket connector
-
1x THT-1N4001 flyback suppression diode
-
1x THT-2N3904 (TO-92) BJT transistor
-
3x THT-LED green+orange+red (tx/rx/pwr-indicator)
-
2x THT variable resistors 3-pin (~50-1kOhm)
-
1x THT-3.5mm socket (optional)
-
1x cable for PTT (optional)
-
1x enclosure/box (recommended)
-
1x Soldering iron
-
Solder + flux + IPA
No need for that.
-
set up antenna, LNA, Transceiver and cables & adapters
-
connect PTT (optional)
-
turn on +5V power supply
-
Have Fun 73
©️ 10/10/2023 WodoWiesel
Github (https://github.com/wodowiesel/)
Twitch (https://www.twitch.com/wodowiesel/)
Instagram (https://www.instagram.com/wodowiesel/)
YT (https://www.youtube.com/@wodowiesel/)
E-Mail ([email protected])
The new design was checked by the electrical engineer theBrutzler (https://github.com/theBrutzler/)
The new optimized PCB was designed with free KiCAD software (https://www.kicad.org/)
❗ The PCB should be produced at a manufacturer
(like PCBWay or similar) with the RoHS lead-free option for environmental protection.
- Hardware
CERN Open Hardware License Version 2 - Weakly Reciprocal
Short identifier CERN-OHL-W-2.0
- Software
This work is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported License.