New board and connectors on replacement S100105

[kenmaples]

I built a module for my pump that was being replaced (due to recall replacement), so I had the unit here to play with. Everything seemed to be going well until I opened the new unit to do the final install.
The new S100105 unit has a new board and connector. The console\display now connects directly to the board.

[visualapproach]

That's a bummer

[kenmaples]

I hastily threw in some jumpers on both ends of the module I made, and everything is up and running as expected so far.

[BigWebstas]

@kenmaples I have the same new board with the new connector, I am able to get the esp to run the pump/blower etc but i cant get the display to function can i ask what your setup is?

[BigWebstas]

I have tried everything it seems but the display just does this

Heres some shots of the new plug, it plugs straight into the pump board, they also used grey silicone so you cant see the board components or board revision :(

[kenmaples]

@BigWebstas I didn't have to do anything additional with the new board other than throw in the updated connectors. Are you working with a S100105? The board, ignoring all that fantastic epoxy, looks a bit different, Mine is a 6 wire install that I used a D1 mini for.

[BigWebstas]

Mine has 4 wires from the display but the pump has 6 pins. Its a S100205 im guessing the 2 means it has built in wifi, I am thinking that is the issue. I can get it to control the pump but the display does nothing. Thanks for the info