You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
ENVIRONMENT:
Onlykey app 5.5.0, installed via .deb
OS: Linux Mint 21.1 (vera)
Used with: OnlyKey v3.0.4-prodc
ISSUE:
The OnlyKey App SETUP tab text displays as shown in the attached screenshot:
However, if you copy and paste that text block elsewhere, it shows the following content:
"Before selecting an option below, you must first put your OnlyKeyDUO into config mode.
To do this hold down button #6 on your OnlyKey for 5+ seconds and release. hold down button #1 on your OnlyKey DUO for 10+ seconds and release.The light will turn off. If a PIN was previously set, re-enter the PIN to enter config mode.You will notice the OnlyKey flashes red in config mode."
RECOMMENDED CHANGE:
Fix formatting so correct text is displayed
Correct inconsistencies between OnlyKEY and OnlyKey DUO
Fix capitalization typo ("... and release. Hold down Button 1 ..."
Potential replacement text (I cannot confirm this is correct for the OnlyKey DUO):
"Before selecting an option below, you must first put your OnlyKey or OnlyKey DUO into config mode.
To do this,
Hold down button 6 on your OnlyKey for 5+ seconds and release
Hold down button 1 on your OnlyKey DUO for 10+ seconds and release.
The light will turn off. If a PIN was previously set, re-enter the PIN to enter config mode. You will notice the OnlyKey or Onlykey Duo flashes red in config mode."
Thanks.
The text was updated successfully, but these errors were encountered:
ENVIRONMENT:
Onlykey app 5.5.0, installed via .deb
OS: Linux Mint 21.1 (vera)
Used with: OnlyKey v3.0.4-prodc
ISSUE:
The OnlyKey App SETUP tab text displays as shown in the attached screenshot:
However, if you copy and paste that text block elsewhere, it shows the following content:
"Before selecting an option below, you must first put your OnlyKeyDUO into config mode.
To do this hold down button #6 on your OnlyKey for 5+ seconds and release. hold down button #1 on your OnlyKey DUO for 10+ seconds and release.The light will turn off. If a PIN was previously set, re-enter the PIN to enter config mode.You will notice the OnlyKey flashes red in config mode."
RECOMMENDED CHANGE:
Potential replacement text (I cannot confirm this is correct for the OnlyKey DUO):
"Before selecting an option below, you must first put your OnlyKey or OnlyKey DUO into config mode.
To do this,
The light will turn off. If a PIN was previously set, re-enter the PIN to enter config mode. You will notice the OnlyKey or Onlykey Duo flashes red in config mode."
Thanks.
The text was updated successfully, but these errors were encountered: