Skip to content

Latest commit

 

History

History
84 lines (64 loc) · 2.96 KB

COMPILER_TESTS.md

File metadata and controls

84 lines (64 loc) · 2.96 KB
Raw

Compiler Test Documentation

In the Rust project, we use a special set of commands embedded in comments to test the Rust compiler. There are two groups of commands:

  1. Header commands
  2. Error info commands

Both types of commands are inside comments, but header commands should be in a comment before any code.

Summary of Error Info Commands

Error commands specify something about certain lines of the program. They tell the test what kind of error and what message you are expecting.

  • ~: Associates the following error level and message with the current line
  • ~|: Associates the following error level and message with the same line as the previous comment
  • ~^: Associates the following error level and message with the previous line. Each caret (^) that you add adds a line to this, so ~^^^^^^^ is seven lines up.

The error levels that you can have are:

  1. ERROR
  2. WARNING
  3. NOTE
  4. HELP and SUGGESTION*

* Note: SUGGESTION must follow immediately after HELP.

Summary of Header Commands

Header commands specify something about the entire test file as a whole, instead of just a few lines inside the test.

  • ignore-X where X is an architecture, OS or stage will ignore the test accordingly
  • ignore-pretty will not compile the pretty-printed test (this is done to test the pretty-printer, but might not always work)
  • ignore-test always ignores the test
  • ignore-lldb and ignore-gdb will skip the debuginfo tests
  • min-{gdb,lldb}-version
  • should-fail indicates that the test should fail; used for "meta testing", where we test the compiletest program itself to check that it will generate errors in appropriate scenarios. This header is ignored for pretty-printer tests.

Revisions

Certain classes of tests support "revisions" (as of the time of this writing, this includes run-pass, compile-fail, run-fail, and incremental, though incremental tests are somewhat different). Revisions allow a single test file to be used for multiple tests. This is done by adding a special header at the top of the file:

// revisions: foo bar baz

This will result in the test being compiled (and tested) three times, once with --cfg foo, once with --cfg bar, and once with --cfg baz. You can therefore use #[cfg(foo)] etc within the test to tweak each of these results.

You can also customize headers and expected error messages to a particular revision. To do this, add [foo] (or bar, baz, etc) after the // comment, like so:

// A flag to pass in only for cfg `foo`:
//[foo]compile-flags: -Z verbose

#[cfg(foo)]
fn test_foo() {
    let x: usize = 32_u32; //[foo]~ ERROR mismatched types
}

Note that not all headers have meaning when customized too a revision. For example, the ignore-test header (and all "ignore" headers) currently only apply to the test as a whole, not to particular revisions. The only headers that are intended to really work when customized to a revision are error patterns and compiler flags.