Board: Nucleo F303
The Nucleo-F303 is a board from ST's Nucleo family supporting a ARM Cortex-M4 STM32F303RE microcontroller with 64Kb of RAM and 512Kb of ROM.
| MCU | STM32F303RE |
|---|---|
| Family | ARM Cortex-M4 |
| Vendor | ST Microelectronics |
| RAM | 64Kb |
| Flash | 512Kb |
| Frequency | up to 72MHz) |
| FPU | yes |
| Timers | 14 (13x 16-bit, 1x 32-bit [TIM2]) |
| ADCs | 4x 12-bit |
| UARTs | 5 |
| SPIs | 4 |
| I2Cs | 3 |
| RTC | 1 |
| Vcc | 2.0V - 3.6V |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
| Device | ID | Supported | Comments |
|---|---|---|---|
| MCU | STM32F303RE | partly | Energy saving modes not fully utilized |
| Low-level driver | GPIO | yes | |
| PWM | one PWM | ||
| UART | three UART | ||
| I2C | two I2C | ||
| SPI | two SPI | ||
| USB | no | ||
| Timer | one 32 timer |
The ST Nucleo-F303RE board includes an on-board ST-LINK V2 programmer. The easiest way to program the board is to use OpenOCD. Once you have installed OpenOCD (look here for installation instructions), you can flash the board simply by typing
make flash
and debug via GDB by simply typing
make debug
For using the ST Nucleo-F303RE board we strongly recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.