Replies: 4 comments 1 reply
-
|
|
Beta Was this translation helpful? Give feedback.
-
|
What is the board you have? If it is an ST Kit you should be using one of the ST Discovery or Nucleo for the 411, not the WEACT. |
Beta Was this translation helpful? Give feedback.
-
|
If using a serial port for connection, does it require TTL conversion? How to configure it |
Beta Was this translation helpful? Give feedback.
-
|
Do I need to use two power cords to connect the microcontroller when installing with DFU? I can use DFU to burn the framework by short circuiting 3.3V, but I cannot connect it using VS2022. Why is this? |
Beta Was this translation helpful? Give feedback.
-
|
This is a question not an issue. Transfering. |
Beta Was this translation helpful? Give feedback.
-
Location
Docs website
Description
I have already burned the firmware and connected it using a virtual serial port and USB. The virtual serial port keeps going online and offline again. When I checked with an oscilloscope, I found that the voltage was always 3.3V
Screenshots
How should this be resolved
Beta Was this translation helpful? Give feedback.
All reactions