Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

Orbiter Filament Sensor + Klipper #180

Open
pauloeduardogodoy opened this issue Jun 5, 2023 · 1 comment
Open

Orbiter Filament Sensor + Klipper #180

pauloeduardogodoy opened this issue Jun 5, 2023 · 1 comment

Comments

@pauloeduardogodoy
Copy link

I just bought an Orbiter Filament Sensor (v2.2) and want to connect it to my MKS ROBIN E3D.
What pins can I use?

These are the instructions extracted from the Orbiter website. My board has the filament sensor pins, but I have no clue where could I connect the filament unload signal…

Connect the FS (Filament sensor signal) pin and the FU (Filament unload signal) to spare digital inputs of your main board. Best is to use pins from spare pin headers or unused expander board connections. Supply the sensor board with +3.3V and GND. 

It is not recommended the use inputs with pull up resistor to 5V like end stop inputs. If these are the only spare inputs you have you may use them but in this case supply the sensor board also with 5V!
@pauloeduardogodoy
Copy link
Author

Looks like MKS hardware is abandoned... No response from the support in months... This is my second post without any comments from the manufacturer/support guys...

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Assignees
No one assigned
Labels
None yet
Projects
None yet
Milestone
No milestone
Development

No branches or pull requests
1 participant
@pauloeduardogodoy