[FR] Adjust Z-Offset when not printing

[DruckiMcDruck]

Klipper is able to accept Z-offset settings before (or after) a print. Currently mainsail only shows the z-offset box while printing. I'd like to adjust the z-offset via the box before starting a print, as i sometimes know that i need a z offset before i hit "print".

Also being able to change the available offset options would be awesome.

[meteyou]

there will be an option to enable this panel the whole time in the next release.

I personally see the problem somewhere else if you know it beforehand anyway, but since it is now very often requested, I will add it.

[DruckiMcDruck]

It's mostly just me being lazy. I could either change my endstop position physically on the printer or inside printer.cfg, but instead i sometimes just change the z-offset before starting a print.

Thank you for adding it :)

[Stephan3]

I use zoffset too outside of printing state. #34