Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

No Rx from Inverter, please help #940

Closed
3 of 5 tasks
walter-in-space opened this issue May 13, 2023 · 5 comments
Closed
3 of 5 tasks

No Rx from Inverter, please help #940

walter-in-space opened this issue May 13, 2023 · 5 comments

Comments

@walter-in-space
Copy link

Hardware

ESP8266 D1 Mini Clone from Amzn
Inverter: HM-800

nRF24L01+ Module

  • [x ] nRF24L01+ you verified this is a Plus model capable of the required 256kBit/s mode
  • [?] square dot indicates original Nordic Semicon chip
  • [?] round dot indicates copy-cat / counterfeit SI labs chip

Antenna:

  • circuit board

Power Stabilization:

  • 330uF Electrolytic Capacitor
    connected between +3.3V and GND (Pin 1 & 2) of the NRF Module
  • [-] Voltage stabilizing motherboard

Version / Git SHA:

Version: 0.6.9
Github Hash: 16ec6a0

Build & Flash Method:

  • AhoyDTU Webinstaller

Debugging:

  • USB Serial Log (attached)
  • Setup settings (use our templates ... to be added)

Module seems to be online, but Never received a single byte.
250 kBit
I tried four equal RF-modules, three in the picture. No success.
Please help, what can I test?

IMG_0910
IMG_0382
IMG_0383
IMG_0384

@rmayergfx
Copy link

Please show us the settings from System Config.
Are both LED to set off/default?
SCLK/MOSI/MISO with valid data or 0?

@walter-in-space
Copy link
Author

All left default.
No extra LEDs connected.

IMG_0385

@rmayergfx
Copy link

rmayergfx commented May 13, 2023

Plz check wiring and GPIO like described here:
https://github.com/lumapu/ahoy/blob/main/doc/getting-started-ESP8266.md

maybe this also can help you:
#36

@kkro
Copy link

kkro commented May 13, 2023

As #36 says:
Hardware: Changed D4/D3 and in software config too.
"Inverter #0: HM-800 (v0) is available and is producing"
It works.

Thank you very much!

May be a little hint on the main-page could help others.

@walter-in-space
Copy link
Author

Solution is #36

Thanks to rmayergfx

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Labels
None yet
Projects
None yet
Development

No branches or pull requests

3 participants