Z axis louder than x and y [BUG]

[dimar01]

Bug

After installing the new firmware (DGUS_TMC_v1.5.3) as well as TMC2209 drivers in my Mega X, the z-axis makes a lot of noise compared to the x- and y-axis

Steps to Reproduce

1. Install TMC 2209
2. Install firmware (MEGA_X_DGUS_TMC_v1.5.3)

Expected behavior: silent axes

Actual behavior: noisy z axis

Additional Information

I'll upload a video to show the problem

file.set.mp4

[knutwurst]

Did you load the firmware defaults after flashing? To be honest: That doesn't sound so bad. It's about the maximum speed that the Z axis can use. I chose it like that so that Z-hops are also possible with the mega x. Since you have installed the TMC2209 driver, the other axes seem a lot quieter.

But you can also limit the maximum speed of Z via gcode. Then the printer is a bit slower, but also quieter.

[dimar01]

Look at the video it doesn't work but live the noise is really loud and annoying. I also tried to put the file for the mega s printer and the noise disappears, but it doesn't take me home